System Management
362
Basic System Configuration Guide
3HE 11010 AAAC TQZZA Edition: 01
zone
Syntax zone {std-zone-name | non-std-zone-name} [hh [:mm]]
no zone
Context config>system>time
Description This command sets the time zone and/or time zone offset for the device.
The 7705 SAR supports system-defined and user-defined time zones. The system-defined
time zones are listed in Table 23.
For user-defined time zones, the zone and the UTC offset must be specified.
The no form of the command reverts to the default of Coordinated Universal Time (UTC). If
the time zone in use was a user-defined time zone, the time zone will be deleted. If a dst-zone
command has been configured that references the zone, the summer commands must be
deleted before the zone can be reset to UTC.
Default zone utc - the time zone is set for Coordinated Universal Time (UTC)
Parameters std-zone-name — the standard time zone name. The standard name must be a system-
defined zone in Table 23. For zone names in the table that have an implicit summer
time setting, for example MDT for Mountain Daylight Saving Time, the remaining
start-date, end-date and offset parameters need to be provided unless it is necessary
to override the system defaults for the time zone.
For system-defined time zones, a different offset cannot be specified. If a new time
zone is needed with a different offset, the user must create a new time zone. Some
system-defined time zones have implicit summer time settings that causes the
switchover to summer time to occur automatically; in this case, configuring the dst-
zone parameter is not required.
A user-defined time zone name is case-sensitive and can be up to 5 characters in
length.
Values A user-defined value can be up to 5 characters or one of the
following values:
GMT, BST, IST, WET, WEST, CET, CEST, EET, EEST, MSK, MSD,
AST, ADT, EST, EDT, ET, CST, CDT, CT, MST, MDT, MT, PST,
PDT, PT, HST, AKST, AKDT, WAST, CAST, EAST
non-std-zone-name — the non-standard time zone name
Values Up to 5 characters maximum.
hh [:mm] — the hours and minutes offset from UTC time, expressed as integers. Some
time zones do not have an offset that is an integral number of hours. In these
instances, the minutes-offset must be specified. For example, the time zone in
Pirlanngimpi, Australia is UTC + 9.5 hours.
To Next Page
Loading...
