System Management
366
Basic System Configuration Guide
3HE 11010 AAAC TQZZA Edition: 01
results
Syntax [no] results file-url
Context config>cron>action
Description This command specifies the location where the system writes the output of an event script’s
execution.
The no form of this command removes the file location from the configuration.
Parameters file-url — specifies the location where the system writes the output of an event script’s
execution (see Table 14 for parameter descriptions)
script
Syntax [no] script script-name [owner owner-name]
Context config>cron>action
Description This command creates action parameters for a script, including the maximum amount of time
to keep the results from a script run, the maximum amount of time a script may run, the
maximum number of script runs to store and the location to store the results.
The no form of this command removes the script parameters from the configuration.
Default n/a
Parameters script-name — connects an event to the script that will run when the event is triggered
owner-name — owner name of the schedule
Default TiMOS CLI
schedule
Syntax [no] schedule schedule-name [owner owner-name]
Context config>cron
Description This command configures the type of schedule to run, including one-time only (oneshot),
periodic, or calendar-based runs. All runs are determined by month, day of month or
weekday, hour, minute and interval (seconds).
The no form of the command removes the context from the configuration.
Default n/a
Parameters schedule-name — name of the schedule
To Next Page
Loading...
