Basic System Configuration Guide System Management
Edition: 01 3HE 11010 AAAC TQZZA 367
owner-name — owner name of the schedule
count
Syntax count number
Context config>cron>schedule
Description This command configures the total number of times a CRON “interval” schedule is run. For
example, if the interval is set to 600 and the count is set to 4, the schedule runs 4 times at
600 second intervals.
Parameters number — the number of times the schedule is run
Values 1 to 65535
Default 65535
day-of-month
Syntax [no] day-of-month {day-number [..day-number] | all}
Context config>cron>schedule
Description This command specifies which days of the month that the schedule will occur. Multiple days
of the month can be specified. When multiple days are configured, each of them will cause
the schedule to trigger. If a day-of-month is configured without configuring month, weekday,
hour and minute, the event will not execute.
Using the weekday command as well as the day-of-month command will cause the script to
run twice. For example, consider that “today” is Monday January 1. If “Tuesday January 5” is
configured, the script will run on Tuesday (tomorrow) as well as January 5 (Friday).
The no form of this command removes the specified day-of-month from the list.
Parameters day-number — positive integers specify the day of the month counting from the first of
the month. The negative integers specify the day of the month counting from the last
day of the month. For example, configuring day-of-month -5, 5 in a month that has
31 days will specify the schedule to occur on the 27th and 5th of that month.
Integer values must map to a valid day for the month in question. For example,
February 30 is not a valid date.
Values 1 to 31, -31 to -1 (maximum 62 day-numbers)
all — specifies all days of the month
To Next Page
Loading...
