System Management
430
Basic System Configuration Guide
3HE 11010 AAAC TQZZA Edition: 01
Output Example
*A:Sar18 Dut-B>show>system# load-balancing-alg
===============================================================================
System-wide Load Balancing Algorithms
===============================================================================
L4 Load Balancing : exclude-L4
LSR Load Balancing :
Hashing Algorithm : lbl-only
Hashing Treatment : profile-1
Use Ingress Port : disabled
System IP Load Balancing : enabled
===============================================================================
*A:Sar18 Dut-B>show>system#
memory-pools
Syntax memory-pools
Context show>system
Description This command displays system memory status.
Output The following output is an example of system memory information, and Table 42 describes
the fields.
Output Example
Table 41 Show System Load-Balancing Algorithm Output Fields
Label Description
System-wide Load Balancing Algorithms
L4 Load Balancing The configured setting for l4-load-balancing
LSR Load Balancing The configured settings for lsr-load-balancing, including:
• Hashing Algorithm
The configured hashing algorithm: lbl-only, lbl-ip, or
lbl-ip-l4-teid
• Hashing Treatment
The configured label stack profile: profile-1, profile-2,
or profile-3
• Use Ingress Port
Specifies whether the ingress port at the LSR is used
System IP Load Balancing Specifies whether the system IP address is used in the
load-balancing calculation
To Next Page
Loading...
