System Management
432
Basic System Configuration Guide
3HE 11010 AAAC TQZZA Edition: 01
ntp
Syntax ntp
Context show>system
Description This command displays NTP protocol configuration and state.
Output The following output is an example of NTP information, and Table 43 describes the fields.
Output Example
A:pc-40>config>system>time>ntp# show system ntp
===============================================================================
NTP Status
===============================================================================
Enabled : Yes Stratum : 3
Admin Status : up Oper Status : up
Server enabled : No Server keyId : none
System Ref Id : 192.168.15.221 Auth Check : Yes
===============================================================================
A:pc-40>config>system>time>ntp# show system ntp all
===============================================================================
NTP Status
===============================================================================
Enabled : Yes Stratum : 3
Admin Status : up Oper Status : up
Server enabled : No Server keyId : none
System Ref Id : 192.168.15.221 Auth Check : Yes
===============================================================================
===============================================================================
NTP Active Associations
===============================================================================
State Remote Reference ID St Type A Poll Reach Offset(ms)
-------------------------------------------------------------------------------
reject 192.168.15.221 192.168.14.50 2 srvr none 64 y 0.901
chosen 192.168.15.221 192.168.14.50 2 mclnt none 64 y 1.101
===============================================================================
A:pc-40>config>system>time>ntp#
A:pc-40>config>system>time>ntp# show system ntp detail
===============================================================================
NTP Status
===============================================================================
Enabled : Yes Stratum : 3
Admin Status : up Oper Status : up
Server enabled : No Server keyId : none
System Ref Id : 192.168.15.221 Auth Check : Yes
Auth Errors : 0 Auth Errors Ignored : 0
Auth Key Id Errors : 0 Auth Key Type Errors : 0
===============================================================================
A:pc-40>config>system>time>ntp#
To Next Page
Loading...
