Basic System Configuration Guide System Management
Edition: 01 3HE 11010 AAAC TQZZA 449
Output Example
A:# show system ptp clock 1 ptp-port 1
===============================================================================
PTP Port
===============================================================================
Admin State : up Number Of Peers : 2
Log-anno-interval : 1 Anno-rx-timeouts : 3
Log-sync-interval : -6 Unicast : True
PTP Port State : slave
===============================================================================
peer
Syntax peer peer-id [detail]
Context show>system>ptp>clock>ptp-port
Description This command displays PTP peer information.
Table 49 Show System PTP Port Output Fields
Label Description
Admin State up — The SNTP server is administratively up
down — The SNTP server is administratively down
Number Of Peers The number of peers associated with this PTP port
Log-anno-interval The expected interval between the reception of announce
messages
Anno-rx-timeouts The number of announce timeouts that need to occur before
communication messages with a master clock are assumed lost
and the master clock is considered not available. One timeout in
this context is equal to the announce interval in seconds,
calculated using the logarithm 2^log-anno-interval-value.
Log-sync-interval The expected interval between the reception of synchronization
messages
Unicast True — the PTP slave clock can unicast-negotiate with the PTP
master clock
False — the PTP slave clock cannot unicast-negotiate with the
PTP master clock
PTP Port State The PTP port state: initializing, listening, uncalibrated, slave,
master, or passive
To Next Page
Loading...
