System Management
448
Basic System Configuration Guide
3HE 11010 AAAC TQZZA Edition: 01
port
Syntax port [port-id [detail]]
Context show>system>ptp>clock
Description This command displays information about configured PTP Ethernet ports. This command
only applies when the clock-id parameter is set to csm.
Parameters port-id — specifies the PTP port ID in the format slot/mda/port
ptp-port
Syntax ptp-port port-id
Context show>system>ptp>clock
Description This command displays PTP port information. This command only applies when the clock-id
parameter value is 1 to 16.
Parameters port-id — specifies the PTP port ID
Values 1 to 50
Output The following output is an example of PTP port information, and Table 49 describes the fields.
Table 48 Show System PTP Clock Timestamp Output Fields
Label Description
Phys Port The physical port identifier
In/Out The direction of the packet counts
Sync Pkt The number of ingress or egress synchronization packets
Delay Req Pkt The number of ingress or egress delay request packets
To Next Page
Loading...
