Basic System Configuration Guide System Management
Edition: 01 3HE 11010 AAAC TQZZA 471
uptime
Syntax uptime
Context show
Description This command displays the time since the system started.
Output The following output is an example of system uptime information, and Table 59 describes the
fields.
Output Example
A:ALU-1# show uptime
System Up Time : 11 days, 18:32:02.22 (hr:min:sec)
A:ALU-1#
Table 58 Show Synchronization Output Fields
Label Description
Standby Status Displays the status of the standby CSM
Last Standby Failure Displays the timestamp of the last standby failure
Standby Up Time Displays the length of time the standby CSM has been up
Failover Time Displays the timestamp when the last redundancy failover
occurred causing a switchover from active to standby CSM. If
there is no redundant CSM card in this system or no failover has
occurred since the system last booted, the value will be 0.
Failover Reason Displays a text string giving an explanation of the cause of the last
redundancy failover. If no failover has occurred, an empty string
displays.
Boot/Config Sync
Mode
Displays the type of synchronization operation to perform
between the primary and secondary CSMs after a change has
been made to the configuration files or the boot environment
information contained in the boot options file (BOF).
Boot/Config Sync
Status
Displays the results of the last synchronization operation between
the primary and secondary CSMs
Last Config File Sync
Time
Displays the timestamp of the last successful synchronization of
the configuration files
Last Boot Env Sync
Time
Displays the timestamp of the last successful synchronization of
the boot environment files
To Next Page
Loading...
