Nokia 7705 - Page 85

Basic System Configuration Guide CLI Usage
Edition: 01 3HE 11010 AAAC TQZZA 85
-------------------------------------------------------------------------------
Addr FECs Sent : 0 Addr FECs Recv : 0
Serv FECs Sent : 0 Serv FECs Recv : 0
...
===============================================================================
group
Syntax group grp-ip-address [source ip-address] [interval interval] [repeat repeat] [absolute | rate]
Context monitor>router>pim
Description This command monitors statistics for a PIM source group.
Parameters grp-ip-address — specifies the IP address of a multicast group that identifies a set of
recipients that are interested in a particular data stream
Values multicast group address (IPv4 or IPv6)
ip-address — specifies the source IP address to use in the ping requests
Values source address (IPv4 or IPv6)
Default 0.0.0.0 to 255.255.255.255
interval — specifies the interval for each display, in seconds
Values 10 | 20 | 30 | 40 | 50 | 60
Default 10
repeat — specifies the number of times the command is repeated
Values 1 to 999
Default 10
absolute — displays raw statistics, without processing. No calculations are performed
on the delta or rate statistics.
rate — displays the rate per second for each statistic, instead of the delta
neighbor
Syntax neighbor neighbor [neighbor...(up to 5 max)] [interval seconds] [repeat repeat] [absolute |
rate]
Context monitor>router>rip
Description This command displays statistical RIP neighbor information at the configured interval until the
configured count is reached.