CLI Usage
86
Basic System Configuration Guide
3HE 11010 AAAC TQZZA Edition: 01
The first screen displays the current statistics related to the specified RIP neighbors. The
subsequent statistical information listed for each interval is displayed as a delta to the
previous screen output. When the keyword rate is specified, the rate per second for each
statistic is displayed instead of the delta.
Monitor commands are similar to show commands but only statistical information is
displayed. Monitor commands display the selected statistics according to the configured
number of times at the interval specified.
Parameters neighbor — the IP address of the neighbor for which to display statistics. Up to 5
neighbors can be specified.
seconds — configures the interval for each display in seconds
repeat — specifies how many times to repeat the command
absolute — displays the raw statistics without processing. No calculations are
performed on the delta or rate statistics.
rate — displays the rate-per-second value for each statistic instead of the delta
instance
Syntax instance interface interface-name vr-id virtual-router-id [ipv6] [interval seconds] [repeat
repeat] [absolute | rate]
Context monitor>router>vrrp
Description This command displays statistics for a VRRP instance.
Parameters interface-name — the name of the existing IP interface on which VRRP is configured
virtual-router-id — the virtual router ID for the existing IP interface, expressed as a
decimal integer
Values 1 to 255
ipv6 — specifies monitoring the IPv6 instance
seconds — configures the interval for each display in seconds
Values 3 to 60
Default 10
repeat — configures how many times the command is repeated
Values 1 to 999
Default 10
absolute — displays raw statistics, without processing. No calculations are performed
on the delta or rate statistics.
rate — specifies the rate per second for each statistic instead of the delta
Default delta
To Next Page
Loading...
