ACCESS GATEWAY
190 System Administration
2.
Enter the definitions you want for each error message in the corresponding fields.
3.
Click on the Save button to save your changes, or click on the Clear Changes button if you want
to reset all the values to their previous state.
If you want to reset all field values to their default state, click on the
Restore Defaults button.
4.
Repeat Steps 1 – 3 for page 2 of 2.
Defining Subscriber Messages {Subscriber Messages}
This procedure allows you to define how “other” subscriber messages are displayed.
There are 3 (three) pages of subscriber messages available.
1.
From the Web Management Interface, click on Subscriber Interface, then Subscriber Messages, 1 of 3.
The Subscriber Page -- Other Message Definitions, 1 of 3 screen appears:
To Next Page
Loading...
