ACCESS GATEWAY
System Administration 197
default setting for this option is “disabled” because ICMP pass- through is a useful end-user troubleshooting
feature and is also required by certain smart clients (for example, GRIC).
1. From the Web Management Interface, click on System, then ICMP. The ICMP screen appears:
2. Click on the check box for
Block ICMP from pending users to enable (or disable) this feature, as
required.
3. You can
Ping a host via the network port by entering either an IP address or DNS name of host.
This is the site that you want the ping to be sent to from the NSE.
4. Click on the
Save button to save your changes, or click on the Restore button to reset all values to
their previous state.
Importing Configuration Settings from the Archive File {Import}
This procedure shows you how to restore the system configuration settings from an archive file (previously
created with the export function).
You will need to reboot the system for some of the imported default settings to take effect
(especially DHCP).
1. From the Web Management Interface, click on System, then Import. The Import Configuration screen
appears:
To Next Page
