ACCESS GATEWAY
206 System Administration
11.
Click Add to add this static port, or click Restore to reset all values to their previous state.
To delete static ports
1.
From the Web Management Interface, click on System, then Static Port-Mapping.The
Static Port-Map screen appears:
2.
Select the item you want to delete.
3.
Click on the Delete button to delete the static port, or click on the Restore button to reset your changes
to their previous state.
For more information about Static Port-Mapping, see also Displaying the Static Port Mapping Table {Static
Port-Mapping} on page 148.
Updating the Access Gateway Firmware {Upgrade}
Upgrading the Access Gateway firmware is performed from the Access Gateway’s Command Line Interface
(CLI) only. Refer to the Firmware Upgrade Procedure (separate document available from Nomadix Technical
Support).
To Next Page
