ACCESS GATEWAY
System Administration 205
2.
Enter the Internal IP Address.
Ensure that the device with the Internal IP Address has been added to the subscriber’s
table.
3.
Enter the Internal Port reference.
4.
Enter a valid MAC Address.
5.
Enter the External IP Address.
The External IP address field will default to the IP address of the Access Gateway.
6.
Enter the External Port reference.
7.
Optional: Enter the Remote IP Address. Leave this field set to zero if you want to connect to the internal
device from any network-side workstation.
8.
Optional: Enable the Protect with Source IP-based Access Control option. Enabling
this will only
allow address in the source-based access control list to connect on this port mapping. Source-based
access control needs to be enabled for this to be in effect.
9.
Optional: Enter the Remote Port reference. Leave this field set to zero if you want to connect to
the device from any TCP/UDP port of a network-side workstation.
10.
Select the protocol (TCP or UDP) from the pull-down menu.
To Next Page
