ACCESS GATEWAY
System Administration 79
The Auto-Configuration setup requires a few basic steps to be completed by both the field engineer
and the NOC administrator.
Administrative Steps to Enable Auto-Config
Typically, these tasks are performed either at a device pre-staging center or by the field engineer.
1.
Establish a WAN connection and electronically accept the EULA.
2.
Setup RADIUS Server parameters (go to Defining the Realm-Based Routing Settings {Realm-
Based Routing} on page 130).
3.
Set up Username and Password for RADIUS Authentication.
Administrative Steps to Enable Auto-Config for the NOC Administrator:
1.
Add NAS IP address.
2.
Add Nomadix Auto-Config VSA to the Nomadix dictionary file on the RADIUS server.
3.
Create a RADIUS profile with the configuration VSA.
4.
Create an FTP server with the configuration files.
5.
The following diagram shows a sample RADIUS configuration file, meta file and illustration of the
FTP server setup.
To Next Page
Loading...
