ProBlue Flex OEM User’s Guide
37
Part 1129255_01
E 2020 Nordson Corporation
Defining System Settings
WARNING! Allow only personnel with appropriate training and experience to
operate or service the equipment. The use of untrained or inexperienced
personnel to operate or service the equipment can result in injury, including
death, to themselves and others, and damage to the equipment.
This section of the manual details those tasks typically performed by a
technician and are usually defined only once.
NOTE: System settings are not saved to a recipe unless indicated.
The following is a list of tasks to be accomplished by a technician:
S Temperature
S Fill/Level
S Flow
S Auto Pump
S System Inputs/Outputs
S Heat Schedule
S Shifts
S User Management
S Preferences
S Networking
Additional Information
This section presents operating procedures in their most commonly used
form. Procedural variations or special considerations are explained in the
additional information table that follows most procedures. Where applicable,
some table entries also contain cross‐reference information. Additional
information tables are indicated by the symbol shown to the left.
To Next Page
Loading...
