Nordson ProBlue Flex - Defining Adhesive Tracking System Alarms

SETUP TOOL
LOAD FROM USB/COMPUTER
USE PREVIOUS FILE
CREATE NEW
Please select how to load a configuration file
FLOW
SYSTEM SETTINGS
ProBlue Flex OEM User’s Guide
58
Part 1129255_01
E 2020 Nordson Corporation
Defining Adhesive Tracking System Alarms
Use the Teach mode to automatically calculate the Target Add-On and
Products to Average values.
1. Log into your BBconn Cloud account, then do the following:
S Select SETUP TOOL - create or load a .NOR file.
S Select SYSTEM SETTINGS | FLOW.
2. From the Monitor Alarm Settings section, enter the following
information. When done, select SAVE.
Setting Description Default Min Max
Alert Enables or disables the system from
monitoring and generating flow Alert
alarms
Note: When an Alert alarm is
generated, production continues, but
attention may be needed.
Disabled N/A N/A
Low Alert Threshold How much lower the add-on weight
(mg) can be from the Target Add-On
value before an Alert alarm is
generated.
.2 * Target
add on
value
.05 *
Target
add on
value
.5 * Target
add on
value
High Alert Threshold How much higher the add-on weight
(mg) can be from the Target Add-On
value before an Alert alarm is
generated.
.3 * Target
add on
value
.05 *
Target
add on
value
.5 * Target
add on
value
Alert Delay Count The number of consecutive
out-of-tolerance products allowed
before the system considers them
defective and generates an Alert
alarm.
4 1 15
Stop Alarm Enables or disables the system from
monitoring and generating flow Stop
alarms.
Note: When a Stop alarm is
generated, production is halted.
Immediate attention is required.
Disabled N/A N/A