SETUP TOOL
LOAD FROM USB/COMPUTER
USE PREVIOUS FILE
CREATE NEW
Please select how to load a configuration file
TEMPERATURE
SYSTEM SETTINGS
ProBlue Flex OEM User’s Guide
41
Part 1129255_01
E 2020 Nordson Corporation
Defining Temperature Setback
Use this setting to define the number of degrees by which all heated
components will be decreased (offset from current set point) when the
controller is placed into Heat Schedule and Manual/Automatic Setback.
1. Log into your BBconn Cloud account, then do the following:
S Select SETUP TOOL - create or load a .NOR file.
S Select SYSTEM SETTINGS | TEMPERATURE.
2. Select Temperature Setback, and enter the temperature offset for any
heated zone that you want to use when the melter is in setback. The
default is 50_ C (90_ F), the minimum is 5_ C (10_ F), and the maximum
is 60_ C (120_ F).
3. When done, select SAVE.
NOTE:
S Regardless of the defined setback temperature, the temperature set point
for any heated zone can only be reduced to 40_ C (100_ F).
To Next Page
Loading...
