Troubleshooting Page 131 of 206
WLAN IP Telephony Installation and Configuration
• RX – Ethernet statistics about the received signal during System Uptime.
— bytes – bytes received
— packets – packets received
— errors – sum of all receive errors (long packet, short packet, CRC,
overrun, alignment)
— drop – packets dropped due to insufficient memory
— fifo – overrun occurred during reception
— alignment – non-octet-aligned packets (number of bits not divisible
by 8)
— multicast – packets received with a broadcast or multicast
destination address
• TX – Ethernet statistics about the transmitted signal during System
Uptime.
— bytes – bytes transmitted
— packets – packets transmitted
— errors – sum of all transmit errors (heartbeat, late collision, repeated
collision, underrun, carrier)
— drop – packets dropped due to insufficient memory
— fifo – underrun occurred during transmission
— carrier – carrier lost during transmission
— collisions – packets deferred (delayed) due to collision
• SVP-II Access Points in Use – number of APs in use by wireless
handsets, either in standby or in a call. ‘Last’ is current, ‘Max’ is the
maximum number in use at one time.
• SVP-II Access Points in Calls – number of APs with wireless handsets
in a call.
• SVP-II Telephones in Use – number of wireless handsets in standby or
in a call.
• SVP-II Telephones in Calls – number of wireless handsets in a call.
To Next Page
Loading...
