Nuova Simonelli PRONTOBAR - Page 115

Pressing ENTER it is possible to enter
the sub menu; the
keys are used
to increase/reduce grinding time.
Press
ENTER
to confirm settings.
SELECT GRINDER Default Grinder Selection
It is possible to set the default grinder (the left SX
Í or the right DX Î).
Pressing ENTER
it is possible to enter the
sub menu; the
keys are used to select the
right or left grinder.
Press
ENTER
to confirm settings.
VOLUME CC. (Water Volume):
It is possible to set the volume of the water for
the coffee in cc.
Pressing
ENTER
it is possible to enter the
sub menu; the
keys are used to increase/
reduce water volume.
Press
ENTER
to confirm settings.
PRE-BREWING (Pre-infusion time):
It is possible to enable/disable the pre-infusion
cycle (YES or NO).
Pressing ENTER
it is possible to enter the
sub menu; the
keys are used to increase/
reduce pre-infusion time
.
Press ENTER
to confirm settings.
TAMPING (Pressing):
It is possible to enable/disable pressing (YES or
NO).
Pressing
ENTER
it is possible to enter the
sub menu; the
keys are used to select
YES or NO to enable/disable pressing.
Press
ENTER
to confirm settings.
MILK TIME (Milk Time):
It is possible to set the time and therefore, the
amount of milk.
Pressing
ENTER
it is possible to enter the
sub menu; the
keys are used to increase/
reduce the amount of milk.
Press ENTER
to
confirm settings.
NO AIR TIME (Air Time disabled):
It is possible to set the part of total milk time in
which the air solenoid is closed so as to adjust
the amount of foam in the milk.
Pressing
ENTER
it is possible to enter
the sub menu; the
keys are used to
increase/reduce the milk time for which
the solenoid valve is closed.
Press
ENTER
to confirm settings.
WASH (Automatic milk tube wash):
It is possible to set the cold water washing time
at the end of milk dispensing.
Pressing
ENTER
it is possible to enter the
sub menu; the
keys are used to increase/
reduce the washing time.
Press
ENTER
to confirm settings.
HOT WATER (Hot Water time):
When pressing the
key in the DOSE menu,
after key 6, you will access to the HOT WATER
menu.
Pressing ENTER
it is possible to enter the
sub menu; the
keys are used to increase/
decrease the time and therefore the volume of
water.
Reading 000 corresponds to disabled key.
Press
ENTER
to confirm settings.
STEAM (Steam Time):
Pressing
key from the cycle menu will open
the STEAM cycle; press ENTER
to open
the submenu; the
keys serve to increase/
reduce the time of the steam,
if the AUTOSTEAM
function is activated,
the keys serve to
increase/reduce the temperature.
Reading 000 corresponds to disabled key.
Press
ENTER
to confirm settings.
Press RESET
to quit the submenu.
To exit programming, press the RESET
but-
ton to get to the "Dose planning" level. With the
up
and down arrows scroll to exit and
press the ENTER
.
Edition 02 to 02/2014
12.9
SERVICE MANUAL