9.5 REPLACE WATERSTOP
VALVE
To replace the waterstop valve in the direct con-
nection version:
1 Turn the machine off and unplug it.
2 Open the rear panel and remove the aquas-
top outlet pipe, pressing the ring.
3 Remove the faston connections.
4 Close the water inlet and disconnect the inlet
pipe.
5 Tilt the machine and with a phillips screw-
driver, undo the two screws holding the sole-
noid.
Edition 02 to 02/2014
9.10
SERVICE MANUAL
Fig. 230
02:11
Fig. 231
02:16
Fig. 232
02:22
Fig. 233
02:26
To Next Page
Loading...
