5 Slide down and remove the front panel.
6 Unhook the water supply pipe by pressing
the fixing ring with a finger or using a flat
head screw driver.
7 Put only the grounds drawer in its position to
close the circuit of the magnetic sensor for
“drawer out” alarm.
8 Connect a 4mm teflon pipe to a manometer.
9 If grounds drawer is well placed and display
reads SELECT PRODUCT, press
to emu-
late the Decaf powder and than Espresso
key. In this way it will be possible to measure
the pump pressure and adjust it by rotating
the screw.
10 Turn the screw clockwise to increase the
pressure and counter clockwise to decrease
it. Suggested pressure is 9 bar.
Edition 02 to 02/2014
9.9
SERVICE MANUAL
Fig. 229
Fig. 228
00:44
To Next Page
Loading...
