Nuova Simonelli PRONTOBAR - Page 50

5 Release the worm screw by undoing the
three 2.5 mm allen screws on top of the sup-
port group.
6 The worm screw is at the back of the infu-
sion chamber. The bearings are part of the
worm screw.
7 Pull out the two runners by removing two 3
mm allen screws, and the 2.5 mm one on the
worm screw cover.
8 To remove the blade ejector, it is necessary
to undo the screw with a 3 mm allen wrench.
Edition 02 to 02/2014
4.10
SERVICE MANUAL
8
Fig. 114
03:59
Fig. 112
03:39
Fig. 113
03:54
5
5
Fig. 111
03:32