Oki Teriostar LP-1030 - User Defined Size

100
LP-1030/LP-1030-MF User's Manual for Basic Printer Operation
T
System Menu

User Dened Size
Sets the roll sizes for the paper series used in the Printer.
n
User Dened 1
n
User Dened 2
n
User Dened 3
n
User Dened 4
<Parameter by selecting numbers>
279.4 mm (11 inches) to
914.4 mm (36 inches)
Default value:
User Dened 1 = 914 mm (35.98 inches)
User Dened 2 = 620 mm (24.41 inches)
User Dened 3 = 450 mm (17.72 inches)
User Dened 4 = 310 mm (12.20 inches)
Note

The input range includes the following restrictions.
(Input value of the upper size -50 mm (-1.97 inches)) to (Input value of the lower
size +50 mm (+1.97 inches))
The upper size refers to the size above the desired user dened size, and
the lower size refers to the size below. For example, with user dened 2, the
upper size is user dened 1, and the lower size is user dened 3.
Setting example:
With all user dened as their default values, the input range is as follows
when changing the size of dened user 2 from 620 mm (24.41 inches) to
another value.
864 mm (34.02 inches) to 500 mm (15.69 inches)

If the values are set outside the input range mentioned above, the setting
values of all the user dened sizes are initialized to their default value when
the Printer restarts.

This setting is available when User Dened series is set to ON in Available
Size Standards.
Before Use Basic Operations Menu Functions
Authentication
function
Troubleshooting Appendix
Chapter
Chapter
Chapter
Chapter
Chapter
1
2
3
4
5