Oki Teriostar LP-1030 - Replacement Precautions

45
T
Replacing the Roll Paper
LP-1030/LP-1030-MF User's Manual for Basic Printer Operation

When the prompt message to supply paper appears, press Alternative
Printing to print with:
- a paper size bigger than the requested paper; or
- a paper type dierent from the requested paper.
However, Alternative Print is not eective when:
- On the print mode, Paper Supply Mode is set to Roll 1, Roll 2, Roll 3,
or Roll4; or
- On the copy mode, Roll Position setting is not Auto.

With rolls other than user dened series, the roll paper width is displayed
as follows. (Changing the unit of length does not change the display.)
A series A0 A1 A2 A3
ARCH series 36 in. 24 in. 18 in. 12 in.
ANSI series 34 in. 22 in. 17 in. 11 in.
30×42 series 30 in.
MAP series 707 mm (27.83 inches) 500 mm (19.69 inches)
DIN series 707 mm (27.83 inches) 500 mm (19.69 inches)
With the user dened series, the screen displays the values, specied at
the User Dened Size 1 to 4, in mm or in inches.
Examples:
234.5 mm, when the unit of length is set to mm.
12.3 in., when the unit of length is set to inches.
Note

If the paper type and the paper series are specied on the supply paper
screen, press Paper to set the paper type and the paper series before
loading the new roll.

Replacement Precautions
Caution

The roll paper is heavy. Be careful not to drop it and injure yourself.

Be careful not to drop the roll paper onto the ange guide. The ange guide
may be damaged.

The ange guide will be damaged if you drop the roll paper when the paper
anges are installed.

Be careful not to trap your hand when opening and closing the roll paper
drawers. When a roll paper drawer is open, do not open the other roll paper
drawer. The risk of trapping your hand will increase.
Before Use Basic Operations Menu Functions
Authentication
function
Troubleshooting Appendix
Chapter
Chapter
Chapter
Chapter
Chapter
1
2
3
4
5