Oki Teriostar LP-1030 - Image Quality Defects

210
LP-1030/LP-1030-MF User's Manual for Basic Printer Operation
Image Quality Defects
This section describes the action to solve printing quality problems. Take action as
appropriate for the symptom.

Action for Image Quality Defects
Symptom Cause Action
Printing is too dark or light ————— Try adjusting the print density.
&
page 88
Printing is partially missing The installed paper type and the
touchpanel setting's paper type do
not match.
Replace the paper or change the
touchpanel setting.
&
page 44
or page 84
The paper is moist. Cut o the top of the roll paper
installed in the Printer.
&
page 44
Set the heater to On.
&
page 40
The installed paper is not OKI Data
Infotech-specied.
Install the OKI Data Infotech-specied
paper.
&
page 27
Black lines appear partially on
the printout.
The service life of the process
cartridge is coming to an end.
Replace the process cartridge.
&
page 64
TIP

The Printer can be set to cut the top of the roll paper automatically
before the next printing operation if the Printer does not print for the
prescribed time or more between the current printing and the next
printing. (
&
page 86, Top Cut Timer (Roll 1-2))
Before Use Basic Operations Menu Functions
Authentication
function
Troubleshooting Appendix
Chapter
Chapter
Chapter
Chapter
Chapter
1
2
3
4
5