Oki Teriostar LP-1030 - PDL Parameter Priority Mode

110
LP-1030/LP-1030-MF User's Manual for Basic Printer Operation
T
Setup Items in PDL Settings Menu

PDL Parameter Priority Mode
In the HP-GL PDL and D-SCAN PDL, by setting a priority mode for the setup
parameters with Data Setting/Panel Setting, the following is activated:
- The setup parameters selected with the data; or
- The setup parameters selected on the Printer
Note that some parameters selected on the Printer is activated even at the data
setting priority mode, when the parameters are not selected with the data.
Settings aected by the parameter mode (only with D-SCAN)
Print Copies
Page Size
Writing Mode
Mirror
Drawing
Identify by Paper Number
Settings aected by the pen parameter mode
Pen n Width
Pen n Density
Pen n Line End *
Pen n Line Join *
* : In the D-SCAN PDL, the Printer setting is always valid.
Note that the Printer's setting is prioritized, and that the setting with the
computer's printer driver screen is invalid on the situation below:
- At the HP-GL PDL setting with a printer driver, the printer driver setting was
deactivated by setting the printer driver option to invalid.
Before Use Basic Operations Menu Functions
Authentication
function
Troubleshooting Appendix
Chapter
Chapter
Chapter
Chapter
Chapter
1
2
3
4
5