Oki Teriostar LP-1030 - Drawing Parameters

116
LP-1030/LP-1030-MF User's Manual for Basic Printer Operation
T
Setup Items in PDL Settings Menu

Drawing Parameters
Drawing parameters specify the print conditions.
n
Parameter Mode (only with D-SCAN)
When a parameter is selected with both data and touchpanel, the parameter mode
species the parameter priority.
<Parameter by selecting options>
n
: Default value
n
Data Setting The parameter specied with data is validated.
Panel Setting The parameter specied with touchpanel is validated.
n
Oset Mode
The oset mode selects Same Drawing Size with Top and Bottom Blank, Oset
with Paper Size Change, or Offset without Paper Size Change as the offset
function.
<Parameter by selecting options>
n
: Default value
n
Same Drawing Size with
Top and Bottom Blank
The parameter selects the same drawing size with the top
and bottom blank as the oset function. The Same Drawing
Size with Top and Bottom Blank setting is enabled.
Oset with
Paper Size Change
The parameter selects the X oset and Y oset as the oset
function. The X Oset and Y Oset settings are enabled. The
page size is increased or decreased by the oset amount.
Oset without
Paper Size Change
The parameter selects the X oset and Y oset as the oset
function. The X Oset and Y Oset settings are enabled. Note
that the oset function does not aect the printed image
size. As a result, the printed image may be clipped. When
the printed image size is not specied, the Printer prints the
image in the Oset with Paper Size Change mode.
n
Same Drawing Size with Top and Bottom Blank
The parameter species the blank space size to add around a printed image at the
same size as the original. Note that the parameter is valid only when the offset
mode is set to Same Drawing Size with Top and Bottom Blank.
<Parameter by entering numbers>
0 to 100 Default value = 0, Unit in mm
Before Use Basic Operations Menu Functions
Authentication
function
Troubleshooting Appendix
Chapter
Chapter
Chapter
Chapter
Chapter
1
2
3
4
5