Oki Teriostar LP-1030 - List of D-SCAN Format Commands

237
LP-1030/LP-1030-MF User's Manual for Basic Printer Operation
T
Command Lists

List of D-SCAN Format Commands
The meaning of the symbols in the table is as follows.
Yes: Indicates commands supported by the Printer.
No: Indicates commands not supported by the Printer (ignored by the Printer).
Category
Command
Function Supported
Name Hexadecimal
Basic
Functions
DUMMY DATA 0000 Indicates the end of the data for each block. Yes
DIMTAB 01 Initializes. No
MESSAGE 02 Outputs a message. No
PEN 03 Species a pen number. Yes
PAUSE 04 Pauses printing. No
EOD 05 Indicates the end of drawing. Yes
INITIAL LOCATION 06 Indicates the initial coordinate location for block 1. Yes
PARABOLA 07 Draws a parabola. Yes
PAPER FEED 08 Shifts the subsequent data in the X axis direction. Yes
SPACING 09 Sets the symbol interval. Yes
KANJI 10 Writes kanji. Yes
H SPACE 0E
Sets the horizontal space for horizontal kanji
writing.
Yes
V SPACE 0F Sets the vertical space for vertical kanji writing. Yes
DUMMY VERB 1F Ignores 1 byte of own data. No
ARC 21 to 3F Draws an arc or circle. Yes
SYMBOL 40 to 7F Writes a symbol. Yes
PLOT 80 to FF Prints a line segment or moves a coordinate. Yes
PTN SET 0001 Registers a ll pattern. Yes
PATRN 0002 Fills the inside of closed polygons. Yes
(1/6)
Before Use Basic Operations Menu Functions
Authentication
function
Troubleshooting Appendix
Chapter
Chapter
Chapter
Chapter
Chapter
1
2
3
4
5