Oki Teriostar LP-1030 - Page 236

236
LP-1030/LP-1030-MF User's Manual for Basic Printer Operation
(2/2)
Command
Function Supported
Name Code
Simple Color ESC * r # u|U Sets the color mode. Yes
Current Pattern ESC * v # t|T Sets the pattern type for the raster. No
Download Pattern ESC * c # W [pattern data] Loads a user dened pattern. No
Pattern Control ESC * c # q|Q
Species the deletion of a user dened
pattern.
No
Pattern ID ESC * c # g|G Sets the ID of a user dened pattern. No
Pattern Reference ESC * p # r|R Denes the paste position for the pattern. No
Logical Operation ESC * l # o|O
Species the logical calculation mode for the
raster data.
Partially (
8
)
Pattern Transparency Mode ESC * v # o|O
Species transparency mode on/o for the
pattern.
No
Source Transparency Mode ESC * v # n|N
Species transparency mode on/o for the
source raster.
No
(
1
) Parameter value -1 is handled as 0.
Parameter values -1 to 3 have no eect on palette information.
(
2
) Parameter values 0 to 3 have no eect on palette information.
(
3
) Partial pages in the received data are not printed.
(
4
) Parameter 4 in Set Pixel Encoding Mode is not supported.
The speciable range in Set Number of Bit per Index is 1 to 8.
The speciable range in Set Number of Bit per Primary is 0 to 8.
(
5
) The speciable parameter range is 0 to 31 (2**5-1).
(
6
) Pushing and popping are not performed for the pen width.
(
7
) The only parameter value enabled for ESC*t#J is 0.
(
8
) ESC*l#O is enabled only in some logical calculations for monochrome binary raster.
Commands not included in the table result in command errors or are disregarded.
T
Command Lists
Before Use Basic Operations Menu Functions
Authentication
function
Troubleshooting Appendix
Chapter
Chapter
Chapter
Chapter
Chapter
1
2
3
4
5