Oki Teriostar LP-1030 - Command Lists

231
LP-1030/LP-1030-MF User's Manual for Basic Printer Operation
Command Lists

List of HP-GL and HP-GL/2 Printer Engine Control Commands
The meaning of the symbols in the table is as follows.
Yes : Indicates commands supported by the Printer.
Partially : Indicates commands whose functions are partially supported by the Printer.
No : Indicates commands not supported by the Printer.
If the Printer receives any non-supported commands, it ignores them. If a command not in
the table is received, a command error results.
Command Function Supported
ESC.(
ESC.Y
Printer on command Yes
ESC.)
ESC.Z
Printer o command Yes
ESC.@ Printer conguration setting command No (
1
)
ESC.A Printer model number output command No (
1
)
ESC.B Buer space output command No (
1
)
ESC.E Enlargement error number output command No (
1
)
ESC.H Handshake mode 1 setting command No (
1
)
ESC.I Handshake mode 2 setting command No (
1
)
ESC.J Printer engine control command aboard command No (
1
)
ESC.K Printing aboard command No (
1
)
ESC.L Logical I/O buer size output command No (
1
)
ESC.M Output setting command No (
1
)
ESC.N
Output mode, handshake mode enlargement setting
command
No (
1
)
ESC.O Enlargement status output command No (
1
)
ESC.P Handshake mode standard setting command No (
1
)
ESC.Q Monitor mode setting command No (
1
)
ESC.R Reset command No (
1
)
ESC.S Buer size output command No (
1
)
ESC T Buer size setting command No (
1
)
ESC.U Flash buer end No (
1
)
(
1
) Because serial communication is not supported.
(
2
) Enabled only for binary raster data. For vector data and variable raster data, only color overlap mode is enabled.
(
3
) The fonts of the font numbers specied with the AD and SD commands are printed with the fonts of the
font numbers indicated in the CS command table below.
(
4
) Recognized as EOF.
Before Use Basic Operations Menu Functions
Authentication
function
Troubleshooting Appendix
Chapter
Chapter
Chapter
Chapter
Chapter
1
2
3
4
5