Oki Teriostar LP-1030 - Pen Parameters (Only with HP-GL and D-SCAN)

132
LP-1030/LP-1030-MF User's Manual for Basic Printer Operation
T
Setup Items in PDL Settings Menu

Pen Parameters (only with HP-GL and D-SCAN)
Pen parameters specify the Printer's drawing pen conditions, e.g., thickness (line
width), and density.
HP-GL: 00 to 15
D-SCAN: 01 to 32
n
Pen Settings
z
Pen Parameter Mode
The parameter selects the data setting or touchpanel setting tospecify the pen
attribute.
<Parameter by selecting options>
n
: Default value
n
Data Setting Enables the data setting for the pen attributes.
Panel Setting Enables the touchpanel setting for the pen attributes.
z
Fine Pen-Width Adjustment
The parameter adjusts the pen width value. The pen width specied with data or
touchpanel setting is increased or decreased by the adjustment value.
Note that the maximum pen width is 16 mm (0.63 inches), and the minimum is 1 dot.
<Parameter by selecting options>
-0.99 to +0.99 Default value = 0
z
Micro-Vector Rounding
The parameter species the shape of the micro-vector's line ends and line joins.
<Parameter by selecting options>
n
: Default value
n
O Line end is specied by the Line End parameter, and Line
join is specied by the Line Join parameter.
On Performs rounding for all micro-vectors.
z
With the Printer, micro-vector is dened as follows:
- The line width and line length are 1 mm or less.
Before Use Basic Operations Menu Functions
Authentication
function
Troubleshooting Appendix
Chapter
Chapter
Chapter
Chapter
Chapter
1
2
3
4
5