Oki Teriostar LP-1030 - Page 134

134
LP-1030/LP-1030-MF User's Manual for Basic Printer Operation
T
Setup Items in PDL Settings Menu
If the density of a thin line is reduced, it may be printed as a dotted line.
In the D-SCAN format, 16 gradations are available for printing.
Specied Values (%) Gradation Specied Values (%) Gradation
0 to 5 1 50 to 56 9
6 to 12 2 57 to 62 10
13 to 18 3 63 to 68 11
19 to 24 4 69 to 74 12
25 to 30 5 75 to 81 13
31 to 37 6 82 to 87 14
38 to 43 7 88 to 93 15
44 to 49 8 94 to 100 16
z
In the HP-GL format, printing is performed in white when the density is 0%.
z
In the D-SCAN format, printing is performed in white when the density is 0 to 5%.
z
Line End
The parameter species the line end shape for the printer's pens.
<Parameter by selecting options>
n
: Default value
n
Round Sets the line end to round.
Butt Sets the line end to butt.
z
The line end shape of these parameters are shown in the gures below.
Round Butt
a
a = 1/2 of line width
z
The printing may take time when the parameter settings are NOT as follows.
Line End to Round; and
Line Join to Round
z
The Line End parameter may not be valid for the outermost line on a drawing.
z
Line Join
The parameter species the line join shape of the Printer's pen.
<Parameter by selecting options>
n
: Default value
n
Round Sets the line join to round.
Mitered Sets the line join to mitered.
z
The connection method of these parameters are shown in the gures below.
Before Use Basic Operations Menu Functions
Authentication
function
Troubleshooting Appendix
Chapter
Chapter
Chapter
Chapter
Chapter
1
2
3
4
5