Oki Teriostar LP-1030 - Page 206

206
LP-1030/LP-1030-MF User's Manual for Basic Printer Operation
T
Error Log Reference
(1) (2) (3) Message Meaning Action
W PD A600 RASTER_DECODE_ERR
An error exists in the format of the compression
raster data.
Check on the computer side
for an error in the format of the
compression raster data.
W PD A601 RASTER_FORMAT_ERR
No raster data of the size specied in the data. Check on the computer side for an
error in the data.
W PD A700 PDL ERR 700
A controller internal format error occurred. When the error persists and there is
a problem in the printout, upgrade
the system.
W PD A701 PDL ERR 701
W PD A702 PDL ERR 702
W PD A703 PDL ERR 703
W PD A704 PDL ERR 704
W PD A705 PDL ERR 705
W PD A800 FORMATERROR
An error exists in the TIFF data. Alternatively,
cannot print because a required tag is missing.
Correct the error on the computer
side.
W PD A801 # OF PARAM. ERROR
The number of parameters for the TIFF data tags
is incorrect.
W PD A802 PARAM._RANGE_ERR
The parameter value for the TIFF data tags is
outside the supported range.
W PD A803 DATA IGNORED
Data was disregarded because there was no
valid print data in the TIFF data.
Check on the computer side whether
valid print data is being transmitted.
W PD A900 FORMATERROR
Cannot print because the required CALS format
record is missing.
Correct the error on the computer
side.
W PM 2300
HDD format execution Restart the Printer, and when the
error persists, upgrade the system.
W PM 7E01
Factory default setting execution
W PM 7E02
Printer initialization execution
W PM B800
Login unauthenticated
W PM C100
Internal communication parameter error
W PM C200
Statuses do not match
W PM C300
Internal process parameter error
W PN 2600
Panel unit not connected
Occurs when a response cannot be received for
the panel initialization command.
(Occurs in a panel task)
W PN 2610
Undened command received
Occurs when an undened command is received
from the panel unit.
(Occurs in a panel task)
Restart the Printer.
W PN 2620 Cmd Retry
Command resent because there was no
response for the command from the panel for a
certain time.
(Occurs in a panel driver)
W PN 2630 Cmd Timeout
Disposed of the command because the
command from the panel was interrupted
partway.
(Occurs in a panel driver)
W PN 2640 Pipe Overow
Disposed of the command from the panel
because of an upper pipe overow.
(Occurs in a panel driver)
-
W RM 2B01 Resource open error
Resource le opening error Restart the Printer.
W SC 2300 Image Over Run
Image disk writing too late Restart the Printer, and when the
error persists, upgrade the system.
W SN 6000
Setup access error -
W SN C000
MIB information construction error -
W SN C010
MIB information access error -
W SN C020
Internal communication error -
W SP A000 Cannot Parse PJL
PJL analysis failed
* Details may be divided into multiple items
Check the print data.
(1) Type (2) Character string (3) Error number
Before Use Basic Operations Menu Functions
Authentication
function
Troubleshooting Appendix
Chapter
Chapter
Chapter
Chapter
Chapter
1
2
3
4
5