Oki Teriostar LP-1030 - Page 234

234
LP-1030/LP-1030-MF User's Manual for Basic Printer Operation
Category Command Function Supported
Enlargement
Commands
NR Not ready command Yes
AF 1 page paper feed command
Partially
AH Half page paper feed command
Partially (
4
)
FR 1 frame paper feed command
Partially (
4
)
PG Printing end command Yes
MG Message display command
No
IM Error mask command Yes
EC Cutter control command Yes
AP Automatic pen status setting command
No
AS Pen acceleration setting command
No
FS Pen pressure setting command
No
VS Pen speed setting command
No
MT Paper type setting command
No
ST Sorting setting command
No
PP Pixel position selection command
No
Digitize
Commands
DC Digitize mode cancellation command
No
DP Digitize mode transition command
No
Output
Commands
OA Pen position, status output command (Printer unit)
No (
1
)
OC Pen position, status output command (user unit)
No (
1
)
OD Digitize position, status output command
No (
1
)
OE Error output command
No (
1
)
OF Printer unit output command No (
1
)
OH Hard clip limit output command
No (
1
)
OI Model ID number output command
No (
1
)
OL Stored character string information output command
No (
1
)
OO Option output command
No (
1
)
OP Scaling point output command
No (
1
)
OS Status output command
No (
1
)
OT Carousel type error command
No (
1
)
OW Window output command
No (
1
)
(
1
) Because serial communication is not supported.
(
2
) Enabled only for binary raster data. For vector data and variable raster data, only color overlap mode is
enabled.
(
3
) The fonts of the font numbers specied with the AD and SD commands are printed with the fonts of the
font numbers indicated in the CS command table below.
(
4
) Recognized as EOF.
AD, SD Specication
Font No.
Corresponding CS
Font No.
AD, SD Specication
Font No.
Corresponding CS
Font No.
AD, SD Specication
Font No.
Corresponding CS
Font No.
AD, SD Specication
Font No.
Corresponding CS
Font No.
0 0 19 31 83 37 563 99
4 32 21 0 85 35 595 5
5 7 36 32 115 30 1611 (Kanji) 101 (Kanji)
6 34 37 35 147 38 1643 (Kanji) 101 (Kanji)
9 36 38 34 267 8
11 6 39 33 277 0
14 0 43 8 531 (Note 1)
(Note 1) Character set 531 is handled as user dened characters.
(3/3)
T
Command Lists
Before Use Basic Operations Menu Functions
Authentication
function
Troubleshooting Appendix
Chapter
Chapter
Chapter
Chapter
Chapter
1
2
3
4
5