Revision History
683
06 December 2003 Information was added on CPU Units Ver. 2.0, on the CJ1M-CPU11/CPU21, on the
CS1W-CIF31, and on the PLS2(887) throughout the manual (see 1-3-7 for overview).
Pages xiii to xxii: PLP information updated.
Section 7: Reworked to include settings for CPU Units Ver. 2.0.
Section 8: Completely reworked.
Page 22: Upper right cell of table corrected.
Page 71, 88, 89, 91, 369, and 370: New products added.
Page 84: Communications specifications added.
Page 218: Note added.
Page 317: Day of month specifications corrected.
07 July 2004 Extensive changes too numerous to list in detail were added for new functionality and new
models.
Page xv: Added information on Loop-control CPU Units.
Pages 17 to 18 and Section 1-4: Added information on CJ1H/CJ1M CPU Unit version
3.0 upgrade.
Sections 2-3 and 3-1: Added new CPU Unit model CJ1H-CPU67H.
Sections 2-5: Added information on Serial Gateway.
Section 3-2: Added information on comment memory.
Section 7-1: Added FB communications instructions settings and Serial Gateway set-
tings.
Section 8-2: Added precautions when changing I/O allocation.
Section 9-11 and Appendix C: Added Free Running Timer (A000 and A001) and func-
tions block information (A34500, A580 to A582) to Auxiliary Area.
Section 10-5: Added new instructions TXDU(256) and RXDU(255), model conversion
instructions XFERC(565), DISTC(566), COLLC(567), MOVBC(568), and
BCNTC(621) and special function block instruction GETID(286). Function block instance
execution time and the number of function block program steps was also added.
08 December 2004 Revisions and additions were made throughout the manual for functionality supported by
Power Supply Units with CS1W-PA205C/PD022, including the following changes.
Page xxiv: Changed table of reference manuals.
Pages xxviii, xxxi, and xxxii: Added precautionary information.
Pages 12 and 14: Added information on battery replacement notification.
Page 22: Added diagram
Pages 89, 97, 104, 127, 164, 217, 228, 490, and 503: Added information to table.
Pages 90, 214, and 272: Added notes.
Page 165: Added diagrams and information on components and dimensions diagrams.
Page 166: Added dimensions diagrams, information on power supply confirmation, and
added models to table.
Page 167: Added models to table and added a new sub section on battery replacement
notification.
Pages 222 and 223: Added dimensions diagrams.
Page 237: Changed diagram and added model number to information on power supply
capacity.
Page 238: Changed diagram.
Page 239: Changed diagram, and added information on power supplies and new models.
Page 241: Added information on alarm output.
Page 359: Corrected address from “CIO 23189” to “CIO 3189” for the Serial PLC Link
Area.
Pages 419, 421, and 422: Added information on power OFF operation and power inter-
ruptions.
Page 538: Changed diagram.
09 October 2006 Information was added on CJ1M CPU Units with unit version 4.0.
Information was added on CJ1-H CPU Units with unit version 4.0.
Descriptions and contents were improved.
The 15-Mbyte flash memory was deleted.
10 April 2007 Information was added on the CJ1H-CPU@@H-R CPU Units.
11 October 2007 Page xi: Added sentence at top of page and added two lines to table.
Page xv: Added note and changed reference to note in table.
Page 54: Changed right two column entries for Overhead time.
Page 76: Corrected EM bank number in fourth column for Extended Data Memory.
Page 109: Corrected number of outputs for Analog I/O Units.
Page 187: Added CJ1W-MD23@ 32-point Units.
Page 206: Removed dot from figure.
Page 207: Corrected wiring diagram.
Page 371: Corrected addresses at the end of the I/O Area.
Page 404: Added paragraph at the bottom of the page.
Page 438: Added columns for names on Programming Console.
Page 439: Corrected symbols in figure and added two minor sections.
Page 512: Removed “CYCLE TIME OVER.”
Page 537: Corrected output specification in next to last row of bottom table.
Page 563: Corrected voltage for input current of input section.
Page 665: Added “(0 V)” to signal name.
Page 666: Corrected two signal names at lower left of block diagram.
Revision code Date Revised content
To Next Page
Loading...
