87
Creating Configuration Data Section 6-2
■ Using a CP1W-CIF41 Ethernet Communications Board
TCP/IP settings, such as the IP address, must be made in the system settings
if an Ethernet Communications Option Board is used. Refer to 7-3 Ethernet
Communications for details on settings.
6-2-5 Displaying and Printing Reports
A report (i.e., a configuration report) on the configuration data that has been
set is displayed on the computer screen to check setting details.
What Is a Report?
The G9SP Configurator creates two types of reports. The characteristics of
each type are given in the following table.
Note (1) Refer to 8-2-3 Verifying the Configuration Data for information on verifica-
tion.
(2) The configuration report can be saved to a file by using commercially
available PDF creation software.
Configuration Data Application Example
■ Documentation Showing the Configuration Data Contents
Forming the details of settings made with the G9SP Configurator into a report
enables using the data for other applications.
■ Notification to Hardware Designers
Hardware designers require information on the I/O terminal allocations, cycle
time, and ON/OFF delay values to create wiring diagrams and to calculate
safety response performance. The report includes that information and can be
used as documentation for notification of details.
Item Configuration report Verification report
Purpose • Documentation showing the
configuration data contents.
• Notification to hardware
designers.
Checking if the configuration
data has been correctly down-
loaded to the G9SP-series
Controller.
Displayed contents Configuration data Verification results and config-
uration data.
Printing Supported Supported
Saving to file Not supported Supported
Display timing When Print Preview is
selected from the File Menu.
After executing Communica-
tion - Verify.
To Next Page
Loading...
