70
Installation Section 5-2
5-2 Installation
This section describes the installation procedure that must be performed to
use the G9SP Configurator.
Precautions for Correct Use
To install the software, log on as a user that meets the following conditions.
• Administrator privileges
• Only single-byte alphanumeric characters in the user's account name (ver-
sion 1.00 only)
5-2-1 Installing the G9SP Configurator
Preparing for Installation
Check the following items before beginning with the installation.
Available Hard Disk Space
The G9SP Configurator can be installed on the hard disk only. At least 200
MB of hard disk space is required. Make sure that there is enough space
available.
Windows Environment and Installation Destination
The G9SP Configurator is a software application for a Windows operating
environment. The software is installed on Windows. Make sure that Windows
is installed and functioning correctly on the computer.
Installation Procedure
This section describes how to install the software on a computer using the fol-
lowing drive configuration as an example.
C drive: Hard disk drive
D drive: CD-ROM drive
1,2,3... 1. Start Windows and insert the G9SP Configurator Master Disk in the CD-
ROM drive. The installation program will be started by the computer’s auto-
run function. If the installation program does not start, select Specify File
Name and Run from the Windows Start Menu, enter “d:\setup” and click
the OK Button.
2. Complete the installation process following the instructions provided on-
screen.
Uninstalling the G9SP Configurator
Uninstall the G9SP Configurator when it is no longer required. Uninstall the
application using Add and Remove Applications in the control panel.
5-2-2 Installing the USB Driver
The USB driver for the G9SP-series Controller must be installed on the com-
puter running the G9SP Configurator in order to connect the G9SP-series
Controller to the computer via USB. The USB driver is stored in the following
directory in the computer when the G9SP Configurator is installed.
\Drivers\USB in the installation folder
To Next Page
Loading...
