Omron G9SP-N20S - Communications Format

124
Ethernet Communications Section 7-3
7-3-1 Communications Format
Command Format (Standard PLC to G9SP-series Controller)
+0 Always 80 hex 1 byte
+1 Always 00 hex 1 byte
+2 Always 02 hex 1 byte
+3 Always 00 hex 1 byte
+4 FINS node address of G9SP-
series Controller
1 byte
+5
Always 00 hex 1 byte
+6 Always 00 hex 1 byte
+7 FINS node address of Stan-
dard PLC
1 byte
+8 Unit number of Communica-
tions Unit in Standard PLC
1 byte
+9 Service ID 1 byte
+10 Always 28 hex 1 byte
+11 Always 01 hex 1 byte
+12
Always 00 hex 1 byte
+13
Always 4B hex 1 byte
+14 Always 03 hex 1 byte
+15 Always 4D hex 1 byte
+16 Always 00 hex 1 byte
+17 Always 01 hex 1 byte
+18 Data 6 bytes
Parameter Description
FINS node address
of G9SP-series Con-
troller
Set the FINS node address that was set for the G9SP-series
Controller. Refer to G9SP-series Controller Settings in 7-3-2
Application Example.
FINS node address
of Standard PLC
Set the FINS node address that was set for the Standard PLC.
Refer to G9SP-series Controller Settings in 7-3-2 Application
Example.
Unit number of Com-
munications Unit in
Standard PLC
Specify the unit number that is set in the Communications
Unit.
Service ID Specify any value between 00 and FF hex.
Data Refer to Reception Data (Standard PLC to G9SP-series Con-
troller) in 7-1-3 Transmission/Reception Data.