Omron G9SP-N20S - Software Design Section 9 Operation and Operating Modes; Software Design; Operation and Operating Modes

139
Software Design
SECTION 9
Operation and Operating Modes
This section describes how to switch the G9SP-series Controllers to RUN Mode.
9-1 G9SP-series Controller Operating Modes. . . . . . . . . . . . . . . . . . . . . . . . . . . . 140
9-2 Changing the Operating Mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 142
9-3 Configuration Lock and Automatic Operation . . . . . . . . . . . . . . . . . . . . . . . . 143
9-4 Changing the Configuration Data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 145
9-5 Operation for Power Supply Interruptions . . . . . . . . . . . . . . . . . . . . . . . . . . . 146
9-5-1 Operation for Voltage Drop . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 146