164
Restoring Data to G9SP-series Controller Section 11-3
11-3 Restoring Data to G9SP-series Controller
This section describes the conditions and procedures for restoring data.
Conditions
The following conditions must be satisfied to restore data.
• Backup of Correct Data on a Memory Cassette
The configuration data must be backed up on a Memory Cassette in
advance.
•Device Password Match
If a device password is set, the device password set for the G9SP-se-
ries Controller must match the device password that is backed up on
the Memory Cassette. A device password is not set in the default set-
tings.
• Prohibit Restore Setting Disabled
The restore prohibition setting made for the G9SP-series Controller
must be disabled. Restore prohibition is enabled in the default settings.
• Model Information (Model) Match
The model information in the configuration data stored on the Memory
Cassette must match the model information in the G9SP-series Con-
troller.
What Is Restore Prohibition?
This setting enables prohibiting restoring data using a Memory Cassette to
prevent incorrect or improper restoration for equipment at the work site. If the
prohibit restore setting is enabled, a computer will be required to update the
configuration data. Be sure to set this setting correctly.
The prohibit restore setting is made in the system settings from the G9SP
Configurator. For the setting procedure, refer to SECTION 6 Creating Configu-
ration Data.
G9SP Configurator
Prohibiting Data
Restoration
Memory Cassette
The computer or Memory Cassette is
used in advance to prohibit restoring data.
Data can still be downloaded to
a G9SP-series Controller for
which restoring data is prohibited.
Data cannot be restored to
a G9SP-series Controller
for which restoring data is
prohibited.
MEMORY
MEMORY
To Next Page
Loading...
