58
Installation Section 4-1
4-1-2 Unit Arrangement
This section describes how to arrange the G9SP-series Controller Units.
As shown in the following diagrams, Units can be arranged in one or two rows
when Expansion I/O Units or Expansion Units are used.
Arrangement in One Row
Expansion I/O Units and Expansion Units can be installed in a side-by-side
arrangement.
Arrangement in Two Rows
The Units can be arranged in two rows using the CP1W-CN811 I/O Connect-
ing Cable (800 mm).
Precautions for Correct Use
I/O Connecting Cable can be used in one place only in each Controller. It can-
not be used between Expansion I/O Units or in more than one place in the
same Controller.
CP-series Expansion I/O Units
G9SP-series Controller
CP1W-CN811
I/O Connecting Cable
To Next Page
Loading...
