Omron G9SP-N20S - Uploading Data from the G9 SP-Series Controller

135
Uploading Data from the G9SP-series Controller Section 8-3
8-3 Uploading Data from the G9SP-series Controller
The final configuration data in the G9SP-series Controller can be uploaded
and restored to the G9SP Configurator.
Procedure
1,2,3... 1. Connect online and then click the Upload Icon ( ).
2. If a parameter password has been set for the configuration data in the
G9SP-series Controller, a dialog box to input the password will appear af-
ter reading the data has been completed. If this dialog box appears, enter
the parameter password.
This step is not required if a parameter password has not been set.
3. If the upload is completed successfully, the configuration data will be dis-
played on the G9SP Configurator. If the parameter password that was en-
tered in step 2 is not correct, the data will be uploaded, but operation will
be restricted.
Additional Information
A parameter password can be set to prevent reproducing the configuration
data uploaded from the G9SP-series Controller so that programming know-
how is not disclosed. (Refer to 6-3 Designing Device Security.)