174
Overview of Troubleshooting Section 13-1
13-1 Overview of Troubleshooting
This section describes how to troubleshoot errors that occur in the G9SP-
series Controller.
13-1-1 Errors and Remedies
Use the following procedure when an error occurs.
13-1-2 Checking the Indicators
The type of error that occurred can be determined by checking the indicators
on the front of the G9SP-series Controller.
Check the indicators.
Problem occurs
Identify the error.
Implement
countermeasures
End
Check the indicators on the front of the
Controller to determine the error status.
Use the G9SP Configurator to read the
detailed error status.
Take measures to eliminate the error
that occurred and to prevent it from
occurring again.
MS FORCE LOCK ERR/
ALM
MC COMM OUT
PWR
I/O Status
Green Red Yellow Yellow Red Yellow Yellow Green Yellow Red
Normal operating status
--- --- --- --- --- Normal operating status after complet-
ing user testing
--- --- --- --- --- Normal operating status during user
testing
--- --- --- --- --- --- Operating status is normal, but the
Safety Output does not turn ON.
Stopped but no error detected
--- --- --- --- --- --- Internal power not supplied
--- --- --- --- --- --- Stopped in IDLE Mode
--- --- --- --- --- --- Stopped in CONFIGURATION Mode
--- --- --- --- --- --- Memory Cassette operation in progress
(backup/restore)
Fatal error detected
--- --- --- --- --- --- --- --- Critical status: System error detected
--- --- --- --- --- --- --- Abort status: Minor error detected
--- --- --- --- --- Error detected in Memory Cassette
operation (backup/restore)
Non-fatal error detected
--- --- --- --- --- --- --- --- --- Non-fatal error detected
To Next Page
Loading...
