134
Downloading Configuration Data to the G9SP-series Controller and Verification Section 8-2
8-2-3 Verifying the Configuration Data
After the download has been completed, a verification is performed to check
that the configuration data that was created has been correctly downloaded to
the G9SP-series Controller. If the verification confirms that the configuration is
correct, a report created from data uploaded from the G9SP-series Controller
will be displayed.
Verified configurations will be indicated by Verified displayed at the lower right
center on the G9SP Configurator.
Precautions for Safe Use
Be sure to use the report that is displayed after the verification has finished to
check that the configuration that was created matches the configuration that
was downloaded.
Verification Procedure
1,2,3... 1. Click the Verify Icon ( ).
2. A verification report will be created if a message appears saying that no
differences were found in the parameters.
3. Check the contents of the report, and then click the Save Button.
4. A message will ask if it is OK to mark the device for a verified configuration.
Click the Yes Button, and the icon will change to Verified.
Additional Information
• To continue by checking I/O wiring or operating status, refer to the following
sections.
Checking I/O wiring → 10-3 Debugging in Force Mode.
Checking operating status → 9-2 Changing the Operating Mode.
• After verifying project files for which safety validation testing (user testing)
was performed, you can also lock the configuration data. Refer to 9-3 Con-
figuration Lock and Automatic Operation for information on locking the con-
figuration data.
To Next Page
Loading...
