49
Option Units Section 2-3
2-3-2 Ethernet Option Board (CP1W-CIF41)
Part Names and Connector Arrangement
Communications Status Indicators
Item Specification
Connection method D-sub, 9-pin female connector
Maximum transmission distance With a baud rate of 9,600 bps: 15 m
With a baud rate of 115,200 bps: 3 m
Communications protocol No-protocol
Maximum data length SECTION 7 Communications with a Standard PLC
Using an Option Board
Frame format Start code 0040 hex
End code Reception bytes: 198
Communica-
tions settings
Baud rate 9,600 or 115,200 bps (unit version 2.0 or later)
Parameters Data length: 8 bits
Stop bits: 1 bit
Parity: Even
Current consumption Included in the current consumption of the G9SP-
series Controller.
Weight Included in the weight of the G9SP-series Control-
ler.
IP ADDRESS:
SUBNET MASK:
COMM ERR
10BASE-T
100BASE-TX
IP Address Label
A label is provided so that the user can enter the
IP address and subnet mask and attach them to
the front of the Unit.
Always enter this information and attach the label
to the Unit.
Ethernet Connector
Used to connect the Ethernet twisted-pair cable.
Indicators
Indicate the operating status of the Option Board.
LED Color Status Meaning
COMM Yellow Not lit Not sending or receiving data.
Lit Sending or receiving data.
ERR Red Not lit The Ethernet Option Board is normal.
Lit A fatal communications error has occurred in
the Ethernet Option Board.
Flashing A non-fatal communications error has
occurred in the Ethernet Option Board.
To Next Page
Loading...
