Omron G9SP-N20S - Page 116

90
Designing Device Security Section 6-3
■ Setting Procedure
1,2,3... 1. In the following dialog box for changing the parameter password, enter the
present parameter password for editing, present password for reading,
new password for editing, and new password for reading. Enter the same
password for editing and reading.
2. Connect the G9SP-series Controller online and then set the device pass-
word.
■ Verification Procedure
1,2,3... 1. The G9SP Configurator will prompt you to input the parameter password
when a project file is opened or configuration data is uploaded. Input the
set password for editing and password for reading.
The project file will open with the edit right if the passwords match. If the
passwords do not match and the Cancel Button is clicked, the project file
will open without rights.
2. The G9SP Configurator will prompt you to input the device password when
downloading or changing modes. Input the set device password.
Input the same
password.
The password must be
between 6 and 16
alphanumeric characters.
Input the same password
for editing and browsing.
The text box will be
empty when no
password is set.
Parameter
password for
editing
Parameter password for
reading
Project file operation rights
Match Edit right
Do not match None