127
Ethernet Communications Section 7-3
FINS/UDP port Specify the UDP port number that is
specified in the FINS communications
service. The UDP port number is a
number used by UDP to identify the
application layer (here, the FINS com-
munications service).
Default value: 0 (9600)
Setting range: 0 to 65535. When set to
0, the FINS/UDP port number is 9600.
No change is
required.
IP address table Set the table that defines correspon-
dence between the FINS node address
and IP address at the Standard PLC.
Set the IP address table when IP rout-
ing is used.
No change is
required.
Parameter Description Set value for this
example
To Next Page
Loading...
