Appendices
A - 72
NX-series EtherNet/IP Coupler Unit User’s Manual (W536)
The following table shows the relationship when the CJ2H-CPU6-EIP CPU Unit is connected.
The following table shows the relationship when the CJ2M-CPU3 CPU Unit is connected.
Function
Change
or addi-
tion
Ether-
Net/IP
Coupler
Unit
Corresponding unit version/version
NX Unit
restric-
tions
CPU Unit CJ1W-EIP21
Nwtwork
Configura-
tor for Eth-
erNet/IP
NX-IO Con-
figurator
CX-Config-
uratorFDT
NX Unit control
with CIP objects
Addition Ver.1.2 Ver.1.5 Ver.2.1 Ver.3.00 Ver.1.00
Ver.2.4
*1
*1. The CX-ConfiguratorFDT with version 2.2 or later can be used if it is connected to the peripheral USB port on the Ether-
Net/IP Coupler Unit.
None
Setting IO-Link
devices from
Support Soft-
ware other than
the Sysmac
Studio con-
nected to
peripheral USB
port on the Eth-
erNet/IP Cou-
pler Unit
Addition Yes
Communica-
tions Interface
Unit control
Addition Yes
BOOTP client Addition None
Function
Change
or addi-
tion
Ether-
Net/IP
Coupler
Unit
Corresponding unit version/version
NX Unit
restric-
tions
CPU Unit CJ1W-EIP21
Nwtwork
Configura-
tor for Eth-
erNet/IP
NX-IO Con-
figurator
CX-Config-
uratorFDT
NX Unit control
with CIP objects
Addition Ver.1.2 Ver.1.0 Ver.2.1 Ver.3.00 Ver.1.00
Ver.2.4
*1
*1. The CX-ConfiguratorFDT with version 2.2 or later can be used if it is connected to the peripheral USB port on the Ether-
Net/IP Coupler Unit.
None
Setting IO-Link
devices from
Support Soft-
ware other than
the Sysmac
Studio con-
nected to
peripheral USB
port on the Eth-
erNet/IP Cou-
pler Unit
Addition Yes
Communica-
tions Interface
Unit control
Addition Yes
BOOTP client Addition None
To Next Page
Loading...
