A - 73
Appendices
NX-series EtherNet/IP Coupler Unit User’s Manual (W536)
A-10 Version Information
A
A-10-2 Functions That Were Added or Changed for Each Unit Version
The following table shows the relationship when the Sysmac Gateway is connected.
Refer to the NX-series Data Reference Manual (Cat. No. W525-E1-03 or later) for the restrictions on
NX Units.
Additions are sometimes made to the NX Units that you can connect when the unit version of the Ether-
Net/IP Coupler Unit is upgraded.
Refer to the NX-series Data Reference Manual (Cat. No. W525-E1-05 or later) for the addition of con-
nectable NX Units.
Function
Change
or addi-
tion
Ether-
Net/IP Cou-
pler Unit
Corresponding unit version/version
NX Unit
restric-
tions
Sysmac
Gateway
Nwtwork
Configura-
tor for Ether-
Net/IP
NX-IO Con-
figurator
CX-Configu-
ratorFDT
NX Unit control with
CIP objects
Addition Ver.1.2 Ver.1.31 Ver.3.00 Ver.1.00
Ver.2.4
*1
*1. The CX-ConfiguratorFDT with version 2.2 or later can be used if it is connected to the peripheral USB port on the Ether-
Net/IP Coupler Unit.
None
Setting IO-Link
devices from Sup-
port Software other
than the Sysmac
Studio connected to
peripheral USB port
on the EtherNet/IP
Coupler Unit
Addition Not possible. Not possible. Not possible. Not possible. Yes
Communications
Interface Unit con-
trol
Addition Ver.1.31 Ver.3.00 Ver.1.00
Ver.2.4
*1
Yes
BOOTP client Addition None
Addition of Connectable NX Units
To Next Page
Loading...
Need help?
General
